A chemiresistive sensor array based on polyaniline nanocomposites and machine learning classification

• Jiri Kroutil,
• Alexandr Laposa,
• Ali Ahmad,
• Jan Voves,
• Vojtech Povolny,
• Ladislav Klimsa,
• Marina Davydova and
• Miroslav Husak

Beilstein J. Nanotechnol. 2022, 13, 411–423, doi:10.3762/bjnano.13.34

• . In most cases, the cross-sensitivity toward different chemical analytes is unavoidable, regardless of their oxidizing or reducing nature. Many authors have suggested a number of ways to overcome the drawbacks of cross-sensitivity/selectivity and reliability of the sensor arrays [3][4][5]. One

Gas sensing properties of individual SnO₂ nanowires and SnO₂ sol–gel nanocomposites

• Alexey V. Shaposhnik,
• Dmitry A. Shaposhnik,
• Sergey Yu. Turishchev,
• Olga A. Chuvenkova,
• Stanislav V. Ryabtsev,
• Alexey A. Vasiliev,
• Xavier Vilanova,
• Francisco Hernandez-Ramirez and
• Joan R. Morante

Beilstein J. Nanotechnol. 2019, 10, 1380–1390, doi:10.3762/bjnano.10.136

• maximal or minimal values of current transfer. As shown in Figure 11, a maximum response in both nanowire and sol–gel sensors is observed at a temperature of around 250 °C. The effect of superficial hydroxy groups on the sensor cross-sensitivity to humidity was investigated in detail in [52]. It was shown

Electrospun one-dimensional nanostructures: a new horizon for gas sensing materials

• Muhammad Imran,
• Nunzio Motta and
• Mahnaz Shafiei

Beilstein J. Nanotechnol. 2018, 9, 2128–2170, doi:10.3762/bjnano.9.202

• by doping with rare earth metals, e.g., Pr2+, Sr2+, and Y [5][7][177]. Many ethanol sensors have similar cross-sensitivity between ethanol and acetone. The sensitivity of a SnO2 gas sensor has been selectively increased from ≈10.8 to ≈18.9 toward 100 ppm of ethanol and the sensitivity toward 100 ppm

• acetone (24.9/100 ppm) at 200 °C compared with pure α-Fe2O3 with response of 5.26 to 100 ppm ethanol at 250 °C. However, the sensor shows cross sensitivity to ethanol and acetone. In comparison to Ca-doped α-Fe2O3, La-doped α-Fe2O3 NTs show a similar response (26/100 ppm) at 240 °C toward acetone with a

Metal oxide nanostructures: preparation, characterization and functional applications as chemical sensors

• Dario Zappa,
• Angela Bertuna,
• Elisabetta Comini,
• Navpreet Kaur,
• Nicola Poli,
• Veronica Sberveglieri and
• Giorgio Sberveglieri

Beilstein J. Nanotechnol. 2017, 8, 1205–1217, doi:10.3762/bjnano.8.122

• metal oxides exhibit cross-sensitivity to other chemical species too. This lack of selectivity toward specific chemical species is one of the major drawbacks of the conductometric use of metal oxides. However, an array of devices based on different materials, each with its own sensing properties (a so

Thin SnO_x films for surface plasmon resonance enhanced ellipsometric gas sensing (SPREE)

• Daniel Fischer,
• Andreas Hertwig,
• Uwe Beck,
• Volkmar Lohse,
• Detlef Negendank,
• Martin Kormunda and
• Norbert Esser

Beilstein J. Nanotechnol. 2017, 8, 522–529, doi:10.3762/bjnano.8.56

• the problems of cross sensitivity of the MOS concept. Results: Undoped tin oxide (SnOx) and iron doped tin oxide (Fe:SnOx) thin add-on films were prepared by magnetron sputtering on the top of the actual surface plasmon resonance (SPR) sensing gold layer. The films were tested for their sensitivity to

Sensitive detection of hydrocarbon gases using electrochemically Pd-modified ZnO chemiresistors

• Elena Dilonardo,
• Michele Penza,
• Marco Alvisi,
• Gennaro Cassano,
• Cinzia Di Franco,
• Francesco Palmisano,
• Luisa Torsi and
• Nicola Cioffi

Beilstein J. Nanotechnol. 2017, 8, 82–90, doi:10.3762/bjnano.8.9

• similar gas sensing layers (e.g., Pd-sensitized ZnO nanobeads [48]). This is probably because of the lower film porosity. A high film porosity is necessary to obtain better results with this HCs gas sensing mechanism [49][50]. To evaluate and compare the cross-sensitivity of the unmodified and Pd-modified

Advances in NO₂ sensing with individual single-walled carbon nanotube transistors

• Kiran Chikkadi,
• Matthias Muoth,
• Cosmin Roman,
• Miroslav Haluska and
• Christofer Hierold

Beilstein J. Nanotechnol. 2014, 5, 2179–2191, doi:10.3762/bjnano.5.227

• nanotube properties into functional ultra-low power, highly sensitive gas sensors. Keywords: carbon nanotube field-effect transistors (CNFETs); cross-sensitivity; functionalization; gas sensors; hysteresis; low power; selectivity; self-heating; single walled carbon nanotubes; Introduction New materials