Humidity-dependent electrical performance of CuO nanowire networks studied by electrochemical impedance spectroscopy

• Jelena Kosmaca,
• Juris Katkevics,
• Jana Andzane,
• Raitis Sondors,
• Liga Jasulaneca,
• Raimonds Meija,
• Kiryl Niherysh,
• Yelyzaveta Rublova and
• Donats Erts

Beilstein J. Nanotechnol. 2023, 14, 683–691, doi:10.3762/bjnano.14.54

• , Riga, Latvia 10.3762/bjnano.14.54 Abstract Electrochemical impedance spectroscopy was applied for studying copper oxide (CuO) nanowire networks assembled between metallic microelectrodes by dielectrophoresis. The influence of relative humidity (RH) on electrical characteristics of the CuO nanowire

• , which was explained by water chemisorption on the nanowire surface [6][13][18][19]. Nevertheless, for single nanowires assembled on electrodes by dielectrophoresis (DEP), the opposite response to humidity was observed [21]. Besides, unusual responses to humidity were shown for nanowires of other

• dielectrophoresis. The impedance of the device increased and remained high at RH up to 50–60% because of the chemisorption of water molecules on the surface of the p-type semiconductor nanowires. It decreased upon exposure to higher RH levels due to physisorption of water molecules atop of the chemisorbed layer and

Studies of probe tip materials by atomic force microscopy: a review

• Ke Xu and
• Yuzhe Liu

Beilstein J. Nanotechnol. 2022, 13, 1256–1267, doi:10.3762/bjnano.13.104

• stabilize carbon nanotube fibers. Slattery et al. [41] prepared carbon nanotube probes by solvent evaporation or dielectrophoresis, the first time a solvent evaporation method was used. From the 13 probes produced using these methods, the CNT-modified nanomaterials showed very high aspect ratios and good

Electrokinetic characterization of synthetic protein nanoparticles

• Daniel F. Quevedo,
• Cody J. Lentz,
• Adriana Coll de Peña,
• Yazmin Hernandez,
• Nahal Habibi,
• Rikako Miki,
• Joerg Lahann and
• Blanca H. Lapizco-Encinas

Beilstein J. Nanotechnol. 2020, 11, 1556–1567, doi:10.3762/bjnano.11.138

• ; bicompartmental particles; dielectrophoresis; electrokinetics; electrophoresis; electro-osmosis; microfluidics; protein nanoparticles; Introduction Over the past 30 years, nanoparticles have been developed for a wide variety of scientific applications, ranging from medical imaging to drug delivery and enzyme

• combination of electrophoresis (EP), dielectrophoresis (DEP), and EO flow effects [22], allowing for additional parameters to fine-tune a separation process. Particle characterization and manipulation with EK techniques offer the potential for developing novel separation schemes for the sorting and enrichment

• methods, although more recently it has been reported that the major phenomena controlling the particles in these systems is the EP of the second kind [25][26]. The use of DEP for protein manipulation via dielectrophoresis chromatography was first reported in 1994 by Washizu et al. [35]. Since then, other

Engineering of oriented carbon nanotubes in composite materials

• Razieh Beigmoradi,
• Abdolreza Samimi and
• Davod Mohebbi-Kalhori

Beilstein J. Nanotechnol. 2018, 9, 415–435, doi:10.3762/bjnano.9.41

• nanofibers containing MWCNTs were successfully fabricated by a magnetic field [110]. Electric field The alignment and orientation of CNTs by an electric field is applied in two ways: as electrophoresis (EP) and dielectrophoresis (DEP). EP is the transport of charged particles through a medium enforced by a

• of Advanced Materials. Schematic of a general dielectrophoresis (DEP) system to fabricate the oriented CNT patterns by an AC electric field. The SEM image of the aligned CNTs adapted with permission from [115], copyright 2011 American Chemical Society. XRD results and SEM images of CNTs with various

Review: Electrostatically actuated nanobeam-based nanoelectromechanical switches – materials solutions and operational conditions

• Liga Jasulaneca,
• Jelena Kosmaca,
• Raimonds Meija,
• Jana Andzane and
• Donats Erts

Beilstein J. Nanotechnol. 2018, 9, 271–300, doi:10.3762/bjnano.9.29

• nanostructures (nanowires, nanotubes, nanorods, graphene) with a good uniformity and desired properties. The microfabrication routine may be supplemented with some bottom-up approaches. Dielectrophoresis [33], controlled nanomaterial growth [34], and nanomanipulation [9] have been demonstrated as useful methods

• . Several CNT-based relays and switches have been fabricated using the bottom-up arrangement of CNTs, including dielectrophoresis [33], controlled growth of CNTs [34][37], dispersion coating [12][35][36], nanomanipulation [15][32] techniques and electron beam lithography/metal sputtering for the fabrication

Sub-nanosecond light-pulse generation with waveguide-coupled carbon nanotube transducers

• Felix Pyatkov,
• Svetlana Khasminskaya,
• Vadim Kovalyuk,
• Frank Hennrich,
• Manfred M. Kappes,
• Gregory N. Goltsman,
• Wolfram H. P. Pernice and
• Ralph Krupke

Beilstein J. Nanotechnol. 2017, 8, 38–44, doi:10.3762/bjnano.8.5

• dielectrophoresis (DEP) [12][13]. DEP allows for site-selective placement of CNTs onto electrodes with their long axis aligned perpendicular to the waveguide [4]. We used gel-filtrated metallic CNTs obtained from HiPco material [14]. The deposition density has been varied in the range of 1–100 CNTs per 1 µm

Dielectrophoresis of gold nanoparticles conjugated to DNA origami structures

• Anja Henning-Knechtel,
• Matthew Wiens,
• Mathias Lakatos,
• Andreas Heerwig,
• Frieder Ostermaier,
• Nora Haufe and
• Michael Mertig

Beilstein J. Nanotechnol. 2016, 7, 948–956, doi:10.3762/bjnano.7.87

• dielectrophoresis. The dielectrophoretic behavior was investigated employing fluorescence microscopy. For the pristine origami, a significant dielectrophoretic response was found to take place in the megahertz range, whereas, due to the higher polarizability of the metallic nanoparticles, the nanoparticle/DNA

• hybrid structures. Keywords: gold nanoparticles; dielectrophoresis; DNA nanotechnology; DNA origami; self-assembly; Introduction The DNA origami method facilitates high throughput synthesis of identical and fully addressable two- (2D) or three-dimensional (3D) nanoscaled structures [1][2][3]. Such DNA

• [15] or – with higher selectivity – by using dielectrophoresis (DEP) [16][17][18][19]. DEP is an electrokinetic phenomenon and results in a force that moves polarizable objects either towards regions with the highest (positive DEP (pDEP)) or lowest electrical field gradient (negative DEP). The

Highly NO₂ sensitive caesium doped graphene oxide conductometric sensors

• Carlo Piloto,
• Marco Notarianni,
• Mahnaz Shafiei,
• Elena Taran,
• Dilini Galpaya,
• Cheng Yan and
• Nunzio Motta

Beilstein J. Nanotechnol. 2014, 5, 1073–1081, doi:10.3762/bjnano.5.120

• using sputtering or by alternating current dielectrophoresis has shown an improvement in the sensitivity to NO by a factor of 5 (down to 2 ppb at room temperature) [15] as well as selectivity to hydrogen [18]. Increasing air pollution and global warming raised the demand for highly sensitive and