1 article(s) from Üzüm, Cagri
(a) Top camera view of the cantilever and the scratch on the film (delimited with the dashed lines)...
Jump to Figure 1
Calculation of the film thickness by the full-indentation method. The dashed lines show the tip-fil...
Jump to Figure 2
Thickness of (PLL/HA)n as a function of n as measured by scratch-and-scan and full-indentation meth...
Jump to Figure 3
(a) A typical force–indentation depth curve as measured by CP-AFM on (PLL/HA)24. The jump point of ...
Jump to Figure 4
Relative percentage Young’s modulus E% for (PLL/HA)72 as measured on one fixed spot. All the values...
Jump to Figure 5
Calculated Young’s modulus E for (PLL/HA)72 with different indentation velocities sorted by (a) the...
Jump to Figure 6
Young’s modulus E as a function of (PLL/HA)n bilayer number n for an indenter radius of 2.37 μm (op...
Jump to Figure 7
A summary of the stress-relaxation measurements. “Start of dwell” is the indentation depth at which...
Jump to Figure 8
Stress relaxation curve with a dwell time of 40 s. The biexponential fit is represented by the thic...
Jump to Figure 9
The cantilever’s stress relaxation time τ1 and τ2 as a function of the initial indentation velocity...
Jump to Figure 10
Beilstein J. Nanotechnol. 2012, 3, 778–788, doi:10.3762/bjnano.3.87
Subscribe to our Latest Articles RSS Feed.
Register and get informed about new articles.
Follow the Beilstein-Institut