Beilstein Journal of Organic Chemistry Beilstein Journal of Organic Chemistry

The degree of reagent and substrate control in the reaction of chiral sulfur ylides with chiral aldehydes has been investigated. Specifically, the reactions of the two enantiomers of the chiral benzyl sulfonium salt 1 with glyceraldehyde acetonide were studied in detail. Of the two new stereogenic centers created, it was found that the C 1 stereochemistry was largely controlled by the reagent, whereas control at the C 2 center was dependent on the aldehyde used. In one case, the trans isomer was produced via reversible formation of the intermediate betaine, whereas in the alternative case, the C 2 center was under Felkin Anh/Cornforth control through non-reversible formation of the betaine. Thus, the aldehyde stereocenter influenced the degree of reversibility in betaine formation, which impacted on the stereocontrol at the C 2 position.


Introduction
The reaction of chiral sulfur ylides with carbonyl compounds, operating in either a catalytic or stoichiometric mode, have emerged as a useful and powerful method in the arsenal of asymmetric transformations. [1] Indeed, near perfect levels of asymmetric induction with high diastereocontrol have been achieved with aromatic aldehydes (Scheme 1). In such reactions, the C 1 stereochemistry is controlled by ylide conformation, face selectivity, and the degree of reversibility in formation of the anti betaine (high reversibility results in low stereocontrol) whilst the C 2 stereochemistry is controlled by the degree of reversibility in syn betaine formation (high reversibility leads to high diastereocontrol in favor of the trans epoxide). [2] We questioned whether the high level of reagent control clearly shown by sulfide 2 could be exploited in reactions with chiral aldehydes and to what extent it might dominate over substrate control (Scheme 2). [3] Again C 1 stereochemistry should be controlled by ylide conformation, face selectivity, degree of reversibility in anti betaine formation, and is not expected to be significantly influenced by the nature (or stereochemistry) of the aldehyde. Therefore, very high levels of reagent control can be expected for the C 1 stereogenic centre. As before, C 2 stereochemistry is controlled by the degree of reversibility in syn betaine formation, and if the addition is non-reversible, will be influenced by the Felkin-Anh selectivity. The degree of reversibility in betaine formation is affected by the nature (and perhaps stereochemistry) of the aldehyde employed.  We therefore examined the reactions of chiral sulfur ylides with chiral aldehydes in order to establish the extent of reagent and substrate control in such systems and chose glyceraldehyde 3 as the substrate (Scheme 3, Scheme 4).

Results and Discussion
The reaction of glyceraldehyde acetonide 3 with the achiral sulfonium salt in the presence of the P 2 base (P 2 = N,N,N',N'-tetramethyl-N"-[tris(dimethylamino)-phosphoranylidene]-phosphoric triamide ethylimine,) [4,5] (sulfur ylide 4) was initially investigated to establish the degree of substrate control. This furnished a mixture of 3 epoxides 7a, 7b, and 7c in a 37:14:49 ratio (  Interestingly, using the more stable ylide 5, which now reacted much more reversibly as evidenced by the higher trans selectivity (96: 4), the C 2 control was similar (84:16) (8a+8c: 8b) to the reaction under kinetic control (Table 1, entry 2). This indicated that the rate of bond rotation or the rate of the ring closure of the two anti betaines (k 5 and k 7 or k 9 and k 11 ) was very similar and that the ratio of epoxides obtained was therefore governed by the rates of betaine formation (k 1 and k 3 ) which again is determined by the degree of Felkin-Anh/Cornforth control by the substrate (Scheme 5). These experiments showed that in the absence of reagent control, low selectivity was observed with semi-stabilized ylides reacting non-reversibly but good levels of diastereocontrol could be achieved with more stabilized ylides reacting reversibly. Interestingly, the amide-stabilized ylide 6, for which betaine formation is expected to be even more reversible, has been reported to give exclusively the trans epoxide 9 but again as an 86: 14 ratio of diastereoisomers. [7] We then turned our attention to reactions of the two chiral sulfur ylide enantiomers ((+)-1/(-)-1) with aldehyde 3 ( Table 1, entry 3 and 5). Interestingly, in both cases, high levels of selectivity for the C 1 position were observed (C 1 (R):C 1 (S) (7a: 7b+7c), 89:11 for (+)-1; 1:99 for (-)-1), indicating that high degrees of reagent control were operative in such systems.
The high degree of trans selectivity observed with (+)-1 (94:6) is indicative of a high degree of reversibility in syn betaine formation (Scheme 6). We suspected that the lower C 1 selectivity observed for (+)-1 relative to (-)-1 resulted from partial reversibility in anti betaine formation. In fact when both syn and anti betaine formation is highly reversible, whilst high trans selectivity is observed, selectivity at C 1 is eroded. This is illustrated with the even more stabilized chiral ylide 11 which, because of its stability, reacted even more reversibly with glyceraldehydes 3 giving even lower C 1 selectivity: 53: 47 for the reaction of (+)-11 and 52: 48 for the reaction of (-)-11 (Table  1, entry 8, entry 9). From earlier studies we had established that the degree of reversibility in betaine formation could be influenced by the degree of solvation of the intermediate alkoxide. The initially formed betaine 9 with charges gauche to each other can either undergo bond rotation to betaine 10 followed by ring closure to give the epoxide 7a or reversion to the ylide and the aldehyde. Solvation of the alkoxide 9 reduces the barrier to bond rotation rendering reactions less reversible. We therefore examined the same reactions in the presence of LiCl (Table 1, entries 4, 6). Now increased C 1 selectivity (C 1 (R):C 1 (S), 96:4) was observed with the reaction of (+)-1, furnishing essentially a single diastereomer in good yield.
In contrast to the reaction of (+)-1, which reacted partially-reversibly with aldehyde 3, (-)-1 reacted essentially non-reversibly as evidenced by the unusually high degree of cis selectivity (the trans isomer is normally favoured in these types of reactions) observed (78:22). In fact the cis isomer 7c was the major diastereomer formed (Scheme 7). Under such non-reversible conditions, the C 1 stereochemistry was controlled by the reagent (C 1 (R):C 1 (S), 1:99) and the C 2 stereochemistry was controlled by the substrate (C 2 (S):C 2 (R), 79:21). Interestingly, the observed C 2 selectivity was similar to that obtained with achiral sulfur ylides, and the observed C 1 selectivity was similar to that obtained with achiral aldehydes. Thus, when the reaction is non-reversible, the C 1 stereochemistry, which is controlled by the reagent, does not influence the C 2 stereochemistry. As such the selectivity at C 2 is controlled in the betaine formation step which is essentially completely controlled by the substrate and not the ylide. In other words the C 1 and C 2 selectivities are controlled essentially independently when betaine formation is non-reversible.
Although we are able to modify the reaction conditions to make betaine formation less reversible, no methods are available at present to make it more reversible.
In conclusion, reaction of the chiral sulfur ylide 1 with the chiral aldehyde glyceraldehyde acetonide 3 gives high reagent control at the C 1 centre. Control at the C 2 centre is more finely balanced and is dependent on whether betaine formation is reversible or not. If betaine formation is reversible, the stereochemistry at C 2 is controlled by the ylide, delivering the trans diastereomer. If betaine formation is non-reversible, the stereochemistry is influenced by pre-existing stereochemistry of the chiral aldehyde (Felkin-Anh/Cornforth control). In this case the C 1 and C 2 stereochemistries are independently controlled with little impact on each other. The factors that we previously noted that influenced reversibility in betaine formation included ylide stability, solvation of the metal alkoxide and steric hindrance around the aldehyde and ylide. [2] We now add another factor to this growing list: stereochemistry of the aldehyde. Evidently, in one isomer, the groups between the aldehyde and ylide mesh well together allowing facile bond rotation from the initially formed gauche betaine to the trans betaine rendering the reaction non-reversible. In the other isomer the groups clash resulting in a higher barrier to bond rotation thus leading to reversible betaine formation. In many respects it is surprising that the subtle effect of stereochemistry of the aldehyde has such a significant impact on the bond rotation step and therefore reversibility of betaine formation.