A novel approach to pulsed laser deposition of platinum catalyst on carbon particles for use in polymer electrolyte membrane fuel cells

• Bogusław Budner,
• Wojciech Tokarz,
• Sławomir Dyjak,
• Andrzej Czerwiński,
• Bartosz Bartosewicz and
• Bartłomiej Jankiewicz

Beilstein J. Nanotechnol. 2023, 14, 190–204, doi:10.3762/bjnano.14.19

• an efficient Pt-based catalyst for polymer electrolyte membrane fuel cells (PEMFCs) by using a cost-effective and efficient physical method to deposit platinum nanoparticles (PtNPs) on carbon supports directly from the platinum target. The method developed avoids the chemical functionalization of the

• thanks to a specially designed electromechanical system that mixed the carbon support particles during platinum deposition. In the studies, Vulcan XC-72R carbon black powder, a popular material used as support in the anodes and cathodes of PEMFCs, and a porous carbon material with a high degree of

• ; ORR; PEMFCs; PLD deposition; Pt catalyst; rotating ring-disk electrode (RRDE); SEM; TEM; XPS; Introduction Fuel cells, which cleanly and efficiently convert the chemical energy of hydrogen or other fuels to electrical energy, are a good alternative to dirty and wasteful combustion engines for

Synthesis of amorphous and graphitized porous nitrogen-doped carbon spheres as oxygen reduction reaction catalysts

• Maximilian Wassner,
• Markus Eckardt,
• Andreas Reyer,
• Thomas Diemant,
• Michael S. Elsaesser,
• R. Jürgen Behm and
• Nicola Hüsing

Beilstein J. Nanotechnol. 2020, 11, 1–15, doi:10.3762/bjnano.11.1

• series, has H2O2 yields between 10% and 20%, whereas the other catalysts show values between 20% and 40%. Regardless of that difference, the values are several times higher than the H2O2 yields obtained for commercial Pt-based catalysts (Figure 8). Hence, for technical applications in conventional PEMFCs

Alloyed Pt₃M (M = Co, Ni) nanoparticles supported on S- and N-doped carbon nanotubes for the oxygen reduction reaction

• Stéphane Louisia,
• Yohann R. J. Thomas,
• Pierre Lecante,
• Marie Heitzmann,
• M. Rosa Axet,
• Pierre-André Jacques and
• Philippe Serp

Beilstein J. Nanotechnol. 2019, 10, 1251–1269, doi:10.3762/bjnano.10.125

• ; nickel; oxygen reduction reaction; platinum; proton exchange membrane fuel cell (PEMFC); Introduction Proton exchange membrane fuel cells (PEMFCs) convert chemical energy from the hydrogen oxidation reaction (HOR) and the oxygen reduction reaction (ORR) into electrical energy. PEMFCs are one of the most

• be done without compromise to the catalyst layer performance and durability. It is known that catalyst degradation via platinum dissolution and carbon corrosion plays an important role in the voltage degradation of PEMFCs [6][7][8]. CB, which is widely used, particularly for its low cost, suffers

Materials and characterization techniques for high-temperature polymer electrolyte membrane fuel cells

• Roswitha Zeis

Beilstein J. Nanotechnol. 2015, 6, 68–83, doi:10.3762/bjnano.6.8

• provides a survey on the materials implemented in state-of-the-art HT-MEAs. These materials must meet extremely demanding requirements because of the severe operating conditions of HT-PEMFCs. They need to be electrochemically and thermally stable in highly acidic environment. The polymer membranes should

• exhibit high proton conductivity in low-hydration and even anhydrous states. Of special concern for phosphoric-acid-doped PBI-type membranes is the acid loss and management during operation. The slow oxygen reduction reaction in HT-PEMFCs remains a challenge. Phosphoric acid tends to adsorb onto the

• and performance of HT-PEMFCs. For this reason, materials characterization techniques for HT-PEMFCs, either in situ or ex situ, are highly beneficial. Significant progress has recently been made in this field, which enables us to gain a better understanding of underlying processes occurring during fuel

Synthesis, characterization, and growth simulations of Cu–Pt bimetallic nanoclusters

• Subarna Khanal,
• Ana Spitale,
• Nabraj Bhattarai,
• Daniel Bahena,
• J. Jesus Velazquez-Salazar,
• Sergio Mejía-Rosales,
• Marcelo M. Mariscal and
• Miguel José-Yacaman

Beilstein J. Nanotechnol. 2014, 5, 1371–1379, doi:10.3762/bjnano.5.150

• electrocatalytic performance towards the oxidation of CO [18][19], methanol oxidation reactions (MOR) [20][21][22][23][24], polymer electrolyte membrane fuel cells (PEMFCs) [15][25][26][27][28], hydrogen storage [29][30], and detecting hydrogen [31]. For instance, Wu et al. [32] studied a series of Pt-based

Design criteria for stable Pt/C fuel cell catalysts

• Josef C. Meier,
• Carolina Galeano,
• Ioannis Katsounaros,
• Jonathon Witte,
• Hans J. Bongard,
• Angel A. Topalov,
• Claudio Baldizzone,
• Stefano Mezzavilla,
• Ferdi Schüth and
• Karl J. J. Mayrhofer

Beilstein J. Nanotechnol. 2014, 5, 44–67, doi:10.3762/bjnano.5.5

• occur in hydrogen fuel cells. A variety of studies have demonstrated that platinum dissolution can occur in PEMFCs during operation, as dissolved platinum was detected in the water stream that exited the fuel cells [43]. Platinum was also found to redeposit in the membrane of PEMFCs as a consequence of