2 article(s) from Wolfrum, Bernhard
Illustration of the two modes of operation: a) Sequential data acquisition: Each intersection is re...
Jump to Figure 1
Redox cycling currents: a) Cyclic voltammogram detected in sequential data acquisition mode at a si...
Jump to Figure 2
Concentration dependency of an intersection in sequential data acquisition. Data was recorded durin...
Jump to Figure 3
Electrochemical recording of the change in concentration during dissolution of a potassium haxacyan...
Jump to Figure 4
Illustration of a future electrochemical setup for parallel spike recording on-chip. By correlation...
Jump to Figure 5
Nanocavity array chip: a) Illustration of a sensor array. The inset sketches a nanocavity sensor th...
Jump to Figure 6
Beilstein J. Nanotechnol. 2014, 5, 1137–1143, doi:10.3762/bjnano.5.124
A) Schematics of the flow cell design for microfluidic anodization. B) An aluminum substrate is ano...
SEM images of the nanoporous alumina film anodized under constant flow conditions.
Impedance plot measured across the nanoporous membrane before (stars) and after (circles) lipid bil...
Impedance and phase measured at 1 kHz across the nanoporous membrane versus driving pressure for th...
The kinetics of the lipid bilayer formation on a nanoporous alumina membrane is shown by measuring ...
Beilstein J. Nanotechnol. 2011, 2, 104–109, doi:10.3762/bjnano.2.12
Subscribe to our Latest Articles RSS Feed.
Register and get informed about new articles.
Follow the Beilstein-Institut