Better together: biomimetic nanomedicines for high performance tumor therapy

• Imran Shair Mohammad,
• Gizem Kursunluoglu,
• Anup Kumar Patel,
• Hafiz Muhammad Ishaq,
• Cansu Umran Tunc,
• Dilek Kanarya,
• Mubashar Rehman,
• Omer Aydin and
• Yin Lifang

Beilstein J. Nanotechnol. 2025, 16, 1246–1276, doi:10.3762/bjnano.16.92

• a certain type of enzyme. The capsosomes can efficiently enter the cell, and the enzymes exert their specific activities intracellularly [101]. More recently, the microfluidic spray technique was used to load alcohol oxidase and catalase into hollow hydrogel microspheres. The microfluidic spray

• technique provided excellent control over the number, type, and spatial control of the enzyme. The enzyme cascade was successfully applied to reduce the alcohol levels as an alternative antidot for alcohol intoxication [102]. 1.4 Exosome-based biomimetic nanoparticles Exosomes are endogenous extracellular

The longstanding challenge of the nanocrystallization of 1,3,5-trinitroperhydro-1,3,5-triazine (RDX)

• Florent Pessina and
• Denis Spitzer

Beilstein J. Nanotechnol. 2017, 8, 452–466, doi:10.3762/bjnano.8.49

• , etc. Ultrasonic spray pyrolysis Since the nineties, spray crystallization and synthesis has been performed using several atomizers, and among them piezoelectric transducers [75][76]. As a spray technique, the goal is to produce one particle per droplet, but here the crystallization is controlled by

Sb₂S₃ grown by ultrasonic spray pyrolysis and its application in a hybrid solar cell

• Erki Kärber,
• Atanas Katerski,
• Ilona Oja Acik,
• Arvo Mere,
• Valdek Mikli and
• Malle Krunks

Beilstein J. Nanotechnol. 2016, 7, 1662–1673, doi:10.3762/bjnano.7.158

• cycles of Sb2S3 deposited, well in line with the JSC values for small area samples with five and nine cycles of Sb2S3 deposited. Ultimately, the true focus of the present study was to obtain a single phase absorber material by spray technique, and the preliminary test of the performance of the material

Photodetectors based on carbon nanotubes deposited by using a spray technique on semi-insulating gallium arsenide

• Domenico Melisi,
• Maria Angela Nitti,
• Marco Valentini,
• Antonio Valentini,
• Teresa Ligonzo,
• Giuseppe De Pascali and
• Marianna Ambrico

Beilstein J. Nanotechnol. 2014, 5, 1999–2006, doi:10.3762/bjnano.5.208

• , 70126, Italy 10.3762/bjnano.5.208 Abstract In this paper, a spray technique is used to perform low temperature deposition of multi-wall carbon nanotubes on semi-insulating gallium arsenide in order to obtain photodectors. A dispersion of nanotube powder in non-polar 1,2-dichloroethane is used as

• ; spray technique; UV–NIR; Introduction Fast photoconductive detectors (PCD) are widely used for the characterization of sub-nanosecond pulses generated from infrared (IR) to ultraviolet (UV) light, X-ray and gamma-ray photons, as well as charged particles [1][2][3]. Applications of carbon nanotubes

• deposition technique for depositing CNTs on silicon, starting from a powder, at low temperatures, without catalyst and an intermediate layer [7]. By using this spray technique, CNT films on silicon-based photodetectors were prepared, achieving quantum efficiency (QE) values in the visible light range