Valorisation of plastic waste via metal-catalysed depolymerisation

• Francesca Liguori,
• Carmen Moreno-Marrodán and
• Pierluigi Barbaro

Beilstein J. Org. Chem. 2021, 17, 589–621, doi:10.3762/bjoc.17.53

• no need of excess of chemicals. Polymerisation was then achieved by raising the reaction temperature, without purification of the intermediate oligomers being required. An interesting one-pot process was developed that combines the use of bioderived chemicals, isosorbide and succinic acid, with PET

• chemical recycling to produce novel polyesters [245]. In this process, isosorbide was used as depolymerising diol to give a mixture of differently composed oligomers, whereas succinic acid was added in the second step as polymerising comonomer (Scheme 7). Both steps were efficiently catalysed by

• monobutyltin oxide, using substoichiometric amounts of isosorbide and succinic acid and no solvent at 230 °C reaction temperature. Isosorbide is a safe chemical [246] that is obtainable on the large scale from renewable glucose [247][248]. Because of this and due to the inherent rigid structure, conferring the

One-pot synthesis of isosorbide from cellulose or lignocellulosic biomass: a challenge?

• Isaline Bonnin,
• Raphaël Mereau,
• Thierry Tassaing and
• Karine De Oliveira Vigier

Beilstein J. Org. Chem. 2020, 16, 1713–1721, doi:10.3762/bjoc.16.143

• 10.3762/bjoc.16.143 Abstract The catalytic conversion of (ligno)cellulose is currently subject of intense research. Isosorbide is one of the interesting products that can be produced from (ligno)cellulose as it can be used for the synthesis of a wide range of pharmaceuticals, chemicals, and polymers

• . Isosorbide is obtained after the hydrolysis of cellulose to glucose, followed by the hydrogenation of glucose to sorbitol that is then dehydrated to isosorbide. The one-pot process requires an acid and a hydrogenation catalyst. Several parameters are of importance during the direct conversion of (ligno

• )cellulose such as the acidity, the crystallinity and the particle size of cellulose as well as the nature of the feedstocks. This review highlights all these parameters and all the strategies employed to produce isosorbide from (ligno)cellulose in a one-pot process. Keywords: catalysis; cellulose

Suzuki–Miyaura cross coupling is not an informative reaction to demonstrate the performance of new solvents

• James Sherwood

Beilstein J. Org. Chem. 2020, 16, 1001–1005, doi:10.3762/bjoc.16.89

• conventional solvents. In this work, the suitability of the Suzuki–Miyaura reaction to demonstrate the usefulness of new solvents was evaluated, including Cyrene™, dimethyl isosorbide, ethyl lactate, 2-methyltetrahydrofuran (2-MeTHF), propylene carbonate, and γ-valerolactone (GVL). It was found that the cross

• lactate [10], 2-methyltetrahydrofuran (2-MeTHF) [11], γ-valerolactone (GVL) [12], dimethyl isosorbide (DMI) [6], and propylene carbonate [7]. This study compares solvents under the same conditions to offer a fair comparison. Additional solvents were included to ensure a range of polarities were

Isosorbide and dimethyl carbonate: a green match

• Fabio Aricò and
• Pietro Tundo

Beilstein J. Org. Chem. 2016, 12, 2256–2266, doi:10.3762/bjoc.12.218

• isosorbide with green reagents and solvent dimethyl carbonate (DMC) is reported. Dehydration of D-sorbitol via DMC in the presence of catalytic amounts of base is an efficient and viable process for the preparation of the industrially relevant anhydro sugar isosorbide. This procedure is “chlorine-free”, one

• -pot, environmental friendly and high yielding. The reactivity of isosorbide with DMC is equally interesting as it can lead to the formation of dicarboxymethyl isosorbide, a potential monomer for isosorbide-based polycarbonate, and dimethyl isosorbide, a high boiling green solvent. The peculiar

• reactivity of isosorbide and the non-toxic properties of DMC represent indeed a green match leading to several industrial appealing potential applications. Keywords: carbohydrate chemistry; D-sorbitol; dimethyl carbonate; green chemistry; isosorbide; Review Introduction In the last twenty years biorefinery

N-Alkylated dinitrones from isosorbide as cross-linkers for unsaturated bio-based polyesters

• Oliver Goerz and
• Helmut Ritter

Beilstein J. Org. Chem. 2014, 10, 902–909, doi:10.3762/bjoc.10.88

• Oliver Goerz Helmut Ritter Institut für Organische und Makromolekulare Chemie, Lehrstuhl für Präparative Polymerchemie, Heinrich-Heine-Universität Düsseldorf, Universitätsstr. 1, 40225 Düsseldorf, Germany 10.3762/bjoc.10.88 Abstract Isosorbide was esterified with acryloyl chloride and crotonic

• acid yielding isosorbide diacrylate (9a) and isosorbide dicrotonate (9b), which were reacted with benzaldehyde oxime in the presence of zinc(II) iodide and boron triflouride etherate as catalysts to obtain N-alkylated dinitrones 10a/b. Poly(isosorbide itaconite -co- succinate) 13 as a bio-based

• ) were used as model systems and reacted with dimethyl itaconate to further characterize the 1,3-dipolaric cycloaddition. Keywords: bio-based polyesters; cross-linkers; dinitrones; 1,3-dipolar cycloaddition; isosorbide; Introduction Nitrones represent a class of compounds with a versatile use as