1 article(s) from Lin, Rong
The standard probe pin configurations A, A’, B and B’ used in the experiments.
Jump to Figure 1
The three sub-probes on an M7PP used for multiplexing during measurements; a) 1357 (20 μm pitch), b...
Jump to Figure 2
The dashed curves show the relative Hall signal ΔRBB′/RH = f(ζ) (Equation 1) and relative pseudo sheet resist...
Jump to Figure 3
Static position errors: at the top, the ideal positions of a M7PP is shown. Below, the case of only...
Jump to Figure 4
Effective sensitivity for a) R0, b) NHS and c) μH when in- and off-line errors are present during ...
Jump to Figure 5
Effective sensitivity for the sheet resistance, Hall mobility and Hall sheet carrier density, due ...
Jump to Figure 6
Generalization of Figure 6. The sensitivity of each parameter, a) Sheet resistance R0, b) Sheet carrier den...
Jump to Figure 7
Beilstein J. Nanotechnol. 2018, 9, 2032–2039, doi:10.3762/bjnano.9.192
Subscribe to our Latest Articles RSS Feed.
Register and get informed about new articles.
Follow the Beilstein-Institut