Investigation of electron-induced cross-linking of self-assembled monolayers by scanning tunneling microscopy

• Patrick Stohmann,
• Sascha Koch,
• Yang Yang,
• Christopher David Kaiser,
• Julian Ehrens,
• Jürgen Schnack,
• Niklas Biere,
• Dario Anselmetti,
• Armin Gölzhäuser and
• Xianghui Zhang

Beilstein J. Nanotechnol. 2022, 13, 462–471, doi:10.3762/bjnano.13.39

• electron energy loss spectroscopy (HREELS) [53][54], Raman spectroscopy [55], and low-energy electron microscopy (LEEM) [56] as well as by theoretical analysis [57][58][59]. It is now well established that electron irradiation leads to cleavage of C–H and S–H bonds, followed by the formation of C–C bonds

• between neighboring aromatic molecules. The mechanisms of cross-linking are dependent on the electron energy: below the ionization potential, a two-step resonant dissociative electron attachment (DEA) has been proposed [5][60][61][62]. Based on HREELS data, Amiaud et al. proposed a resonant electron

Electron interactions with the heteronuclear carbonyl precursor H₂FeRu₃(CO)₁₃ and comparison with HFeCo₃(CO)₁₂: from fundamental gas phase and surface science studies to focused electron beam induced deposition

• Ragesh Kumar T P,
• Paul Weirich,
• Lukas Hrachowina,
• Marc Hanefeld,
• Ragnar Bjornsson,
• Helgi Rafn Hrodmarsson,
• Sven Barth,
• D. Howard Fairbrother,
• Michael Huth and
• Oddur Ingólfsson

Beilstein J. Nanotechnol. 2018, 9, 555–579, doi:10.3762/bjnano.9.53

• ), reflection-absorption IR spectroscopy (RAIRS), and/or high-resolution electron energy loss spectroscopy (HREELS), while mass spectrometry has been used to identify gas phase species generated as a result of electron irradiation. As such the surface science experiments represent an increased level of

Electron-driven and thermal chemistry during water-assisted purification of platinum nanomaterials generated by electron beam induced deposition

• Ziyan Warneke,
• Markus Rohdenburg,
• Jonas Warneke,
• Janina Kopyra and
• Petra Swiderek

Beilstein J. Nanotechnol. 2018, 9, 77–90, doi:10.3762/bjnano.9.10

• of a previous study on the electron-induced decomposition of MeCpPtMe3 by high-resolution electron energy loss spectroscopy (HREELS) [26] which has revealed that the nature of the deposit is similar for E0 = 50 eV and 500 eV. H2O was dosed onto this partially degraded precursor layer without prior

Response under low-energy electron irradiation of a thin film of a potential copper precursor for focused electron beam induced deposition (FEBID)

• Leo Sala,
• Iwona B. Szymańska,
• Céline Dablemont,
• Anne Lafosse and
• Lionel Amiaud

Beilstein J. Nanotechnol. 2018, 9, 57–65, doi:10.3762/bjnano.9.8

• ligands that are solid and stable under ambient conditions. They are directly deposited on the surface for studying the fragmentation with surface science tools. Results: Infrared spectroscopy and high-resolution electron energy loss spectroscopy (HREELS) are combined to show that the precursor is able to

• for ligands fragmentation allow one to envisage the use of the two precursors for FEBID studies. Keywords: amines; copper(II); electron-stimulated desorption; FEBID precursors; HREELS; low-energy electrons; perfluorinated carboxylates; Introduction The high electrical conductivity of copper makes it

• by HREELS. The assignments of the main vibrational modes are listed in Table 1. The comparison between these signatures shows that the complexes, stable at atmospheric pressure in cold and dry environment, evolve when exposed to vacuum and when annealed under vacuum. The decomposition under heating

Distribution of Pd clusters on ultrathin, epitaxial TiO_x films on Pt₃Ti(111)

• Christian Breinlich,
• Maria Buchholz,
• Marco Moors,
• Tobias Pertram,
• Conrad Becker and
• Klaus Wandelt

Beilstein J. Nanotechnol. 2015, 6, 2007–2014, doi:10.3762/bjnano.6.204

• images. Former LEED measurements have shown a commensurate rectangular unit cell with a (6 × 3√3) superstructure with respect to the (1 × 1) spots of the alloy surface and a unit cell size of (16.6 ± 0.2) × (14.4 ± 0.2) Å, while high resolution electron energy loss spectroscopy (HREELS) and X-ray

• '-TiOx phase is the second stable titanium oxide phase that can be grown on the Pt3Ti(111) surface with oxygen doses higher than 200 L within a temperature window of 800–1100 K [6]. HREELS and XPS studies also indicated a Ti–O bilayer structure with oxygen termination as a basic structure element for

The role of low-energy electrons in focused electron beam induced deposition: four case studies of representative precursors

• Rachel M. Thorman,
• Ragesh Kumar T. P.,
• D. Howard Fairbrother and
• Oddur Ingólfsson

Beilstein J. Nanotechnol. 2015, 6, 1904–1926, doi:10.3762/bjnano.6.194

• electron energy loss spectroscopy (HREELS). For experimental details on the UHV surface experiments discussed here, see [25][50]. The shortcoming of these surface experiments is, however, that the precursor molecules are subjected to interactions with SEs with an energy distribution (similar to that in

• , and the potential role of ND in the deposit formation. All of these gas phase studies can be compared with a UHV surface study by Landheer et al. [23], where mass spectrometry was used to monitor desorption of volatile decomposition products and XPS and HREELS were used to monitor the evolution of the

• the chemical composition of the remaining film was probed by XPS, HREELS was used to study the change in vibrational modes of the adsorbed molecules. Figure 15 shows a time-resolved mass spectrum monitoring the PF3 desorption during electron exposure after an initial electron dose of 0, 1.5 × 1014