Current status of using adsorbent nanomaterials for removing microplastics from water supply systems: a mini review

• Nguyen Thi Nhan and
• Tran Le Luu

Beilstein J. Nanotechnol. 2025, 16, 1837–1850, doi:10.3762/bjnano.16.127

• (a) the highest occupied molecular orbital (HOMO) and lowest unoccupied molecular orbital (LUMO) of chitosan (CS), bacterial cellulose (BC), crosslinked CS, and PS. (b) Energy gaps among PS, CS, BC, and crosslinked-CS. (c) scenarios of hardwood vessel-inspired chitosan-based sponges (BGCS)-120

Soft materials nanoarchitectonics: liquid crystals, polymers, gels, biomaterials, and others

• Katsuhiko Ariga

Beilstein J. Nanotechnol. 2025, 16, 1025–1067, doi:10.3762/bjnano.16.77

Micro- and nanotechnology in biomedical engineering for cartilage tissue regeneration in osteoarthritis

• Zahra Nabizadeh,
• Mahmoud Nasrollahzadeh,
• Hamed Daemi,
• Mohamadreza Baghaban Eslaminejad,
• Ali Akbar Shabani,
• Mehdi Dadashpour,
• Majid Mirmohammadkhani and
• Davood Nasrabadi

Beilstein J. Nanotechnol. 2022, 13, 363–389, doi:10.3762/bjnano.13.31

• as potential candidates for bone TE due to osteoblast attachment and corrosion resistance [141]. Wan et al. used bacterial cellulose as a template to synthesize calcined mesoporous TiO2 nanotubes and constructed a nanotube-based scaffold using a template-assisted sol–gel method [142]. In addition to

Nanocellulose: Recent advances and its prospects in environmental remediation

• Katrina Pui Yee Shak,
• Yean Ling Pang and
• Shee Keat Mah

Beilstein J. Nanotechnol. 2018, 9, 2479–2498, doi:10.3762/bjnano.9.232

• ]. As a result, the surface area of this hybrid structure is expected to increase and expand its wavelength response up to the visible range. Bacterial cellulose shows the ability to act as a metal oxide nanoparticle support due to its high surface-area-to-volume ratio with a fibre diameter in the range

• of 40–70 nm, high mechanical strength and super-hydrophilicity properties [123]. Its ultrafine three-dimensional network provides bacterial cellulose with a high specific surface area, owing to the well-separated nano- and microfibrils. Besides, the presence of –OH binding sites and a fibrous network

• can facilitate the adsorption of metal oxide to its surface. Thus, Li et al. [123] proposed the immobilization of TiO2 nanoparticles on a fine fibrous network of bacterial cellulose via hydrogen bonds and electrostatic adsorption effect for the photocatalytic degradation of reactive X-3B. TiO2

The longstanding challenge of the nanocrystallization of 1,3,5-trinitroperhydro-1,3,5-triazine (RDX)

• Florent Pessina and
• Denis Spitzer

Beilstein J. Nanotechnol. 2017, 8, 452–466, doi:10.3762/bjnano.8.49

• bacterial cellulose. The smallest particle size was obtained with a 71% RDX/gelatine mixture. However, increasing the content of RDX leads to an increase in the particle size and the maximum RDX loading tested was 91% resulting in a mean particle diameter of 50 nm. The sensitivity of this composite towards

• impact and friction was reduced by two times, therefore questioning the reactivity. Nevertheless, further efforts were made to replace the bacterial cellulose with an energetic matrix. Crystallization in solution allows the formation of large crystals by growth, thus allowing more parametric studies

Functionalized platinum nanoparticles with surface charge trigged by pH: synthesis, characterization and stability studies

• Giovanna Testa,
• Laura Fontana,
• Iole Venditti and
• Ilaria Fratoddi

Beilstein J. Nanotechnol. 2016, 7, 1822–1828, doi:10.3762/bjnano.7.175

• reducing agents such as nanocrystalline cellulose from cotton or bacterial cellulose matrixes are currently being studied [23][24]. Thiol ligands have been thoroughly investigated [25][26][27] and particular attention has been devoted to hydrophilic ligands that confer to the PtNP stability in water

Mechanical and thermal properties of bacterial-cellulose-fibre-reinforced Mater-Bi^® bionanocomposite

• Hamonangan Nainggolan,
• Saharman Gea,
• Emiliano Bilotti,
• Ton Peijs and
• Sabar D. Hutagalung

Beilstein J. Nanotechnol. 2013, 4, 325–329, doi:10.3762/bjnano.4.37

• Mary University of London, Mile End Road, London E1 4NS, United Kingdom School of Materials and Mineral Resources Engineering, Universiti Sains Malaysia, 14300 Nibong Tebal, Penang, Malaysia 10.3762/bjnano.4.37 Abstract The effects of the addition of fibres of bacterial cellulose (FBC) to commercial

• FBC into Mater-Bi. FBC is easily incorporated in Mater-Bi matrix and produces homogeneous Mater-Bi/FBC composite. The crystallinity of the Mater-Bi/FBC composites decrease in relation to the increase in the volume fraction of FBC. Keywords: bacterial cellulose; bio-nanocomposites; Mater-Bi

• /matrix interface [6]. Cellulose is the main component of plant cell walls. Some bacteria produce cellulose (celled biocellulose or bacterial cellulose). Plant cellulose and bacterial cellulose (BC) have the same chemical structure, but different physical and chemical properties. BC is produced by