Low-temperature AFM with a microwave cavity optomechanical transducer

• Ermes Scarano,
• Elisabet K. Arvidsson,
• August K. Roos,
• Erik Holmgren,
• Riccardo Borgani,
• Mats O. Tholén and
• David B. Haviland

Beilstein J. Nanotechnol. 2025, 16, 1873–1882, doi:10.3762/bjnano.16.130

• experiment, components after the cavity in the measurement chain introduce additional imprecision noise, expressed as an added number of noise photons nadd: The added noise in our setup (Figure 1d) is determined by the cryogenic low-noise amplifier (LNA) mounted at the 4 K stage. We use Planck spectroscopy

Design, fabrication, and characterization of kinetic-inductive force sensors for scanning probe applications

• August K. Roos,
• Ermes Scarano,
• Elisabet K. Arvidsson,
• Erik Holmgren and
• David B. Haviland

Beilstein J. Nanotechnol. 2024, 15, 242–255, doi:10.3762/bjnano.15.23

• passed to the sample. A directional coupler separates incoming and reflected signal. The reflected signal is amplified with a cryogenic low-noise amplifier and additionally amplified at room temperature. A separate port on the microwave platform generates the low-frequency drive to a piezoelectric shaker

A wideband cryogenic microwave low-noise amplifier

• Boris I. Ivanov,
• Dmitri I. Volkhin,
• Ilya L. Novikov,
• Dmitri K. Pitsun,
• Dmitri O. Moskalev,
• Ilya A. Rodionov,
• Evgeni Il’ichev and
• Aleksey G. Vostretsov

Beilstein J. Nanotechnol. 2020, 11, 1484–1491, doi:10.3762/bjnano.11.131

• the presented frequency range. The amplifier is applicable for any type of cryogenic microwave measurements. As an example we demonstrate here the characterization of the superconducting X-mon qubit coupled to an on-chip coplanar waveguide resonator. Keywords: cryogenic low-noise amplifier; high

Cryogenic low-noise amplifiers for measurements with superconducting detectors

• Ilya L. Novikov,
• Boris I. Ivanov,
• Dmitri V. Ponomarev and
• Aleksey G. Vostretsov

Beilstein J. Nanotechnol. 2020, 11, 1316–1320, doi:10.3762/bjnano.11.115

• range from DC to 17 kHz. We experimentally show that the parallel differential circuit design allows for a reduction of the voltage noise from 0.55 to 0.33 nV/Hz0.5 at 77 K. Keywords: cryogenic amplifier; cryogenic low-noise amplifier; differential cryogenic amplifier; superconducting circuit readout