Structural and electronic properties of SnO₂ doped with non-metal elements

• Jianyuan Yu,
• Yingeng Wang,
• Yan Huang,
• Xiuwen Wang,
• Jing Guo,
• Jingkai Yang and
• Hongli Zhao

Beilstein J. Nanotechnol. 2020, 11, 1321–1328, doi:10.3762/bjnano.11.116

• replacement doping. S-doping forms p-type semiconductors, and F-doping forms n-type semiconductors. The optical analysis results revealed that F-doped SnO2 possesses the highest reflectivity in the infrared region, and is most suitable as a low-emissivity coating material. Schematic diagram of the structure

Improved adsorption and degradation performance by S-doping of (001)-TiO₂

• Xiao-Yu Sun,
• Xian Zhang,
• Xiao Sun,
• Ni-Xian Qian,
• Min Wang and
• Yong-Qing Ma

Beilstein J. Nanotechnol. 2019, 10, 2116–2127, doi:10.3762/bjnano.10.206

• , 2, 3, 4 and 5. The S-doped samples synthesized at 250 °C exhibit a significantly improved photocatalytic performance. More precisely, S-doping has the following effects on the material: (1) S can adopt different chemical states in the samples. Specifically, it exists in the form of S2− replacing O2

• − at a ratio of RS/Ti = 1 and also in the form of S6+ replacing Ti4+ at RS/Ti ≥ 2. As a result, S-doping causes a lattice distortion, because the ionic radii of S2− and S6+ differ from that of the O2− and Ti4+ ions. (2) S-doping increases the adsorption coefficient Ae for methylene blue (MB) from 0.9

• % to 68.5% due to the synergistic effects of the oxygen vacancies, increased number of surface chemical adsorption centers as a result of SO42− adsorption on the TiO2 surface and the larger pore size. (3) S-doping increases the MB degradation rate from 6.9 × 10−2 min−1 to 18.2 × 10−2 min−1 due to an

Co-reductive fabrication of carbon nanodots with high quantum yield for bioimaging of bacteria

• Jiajun Wang,
• Xia Liu,
• Gesmi Milcovich,
• Tzu-Yu Chen,
• Edel Durack,
• Sarah Mallen,
• Yongming Ruan,
• Xuexiang Weng and
• Sarah P. Hudson

Beilstein J. Nanotechnol. 2018, 9, 137–145, doi:10.3762/bjnano.9.16

• ][20]. Qu et al. obtained graphene quantum dots with a quantum yield of 78% and 71% using citric acid and urea or citric acid and thiourea as the precursors, respectively. They demonstrated that N or N/S doping led to the high QY of the C-dots. Zeng et al. prepared C-dots with a relatively high QY

Two-dimensional carbon-based nanocomposites for photocatalytic energy generation and environmental remediation applications

• Suneel Kumar,
• Ashish Kumar,
• Ashish Bahuguna,
• Vipul Sharma and
• Venkata Krishnan

Beilstein J. Nanotechnol. 2017, 8, 1571–1600, doi:10.3762/bjnano.8.159

• was fabricated by a one-pot impregnation co-precipitation method as shown in Figure 12a. The S doping was introduced to narrow the band gap of g-C3N4 by stacking its 2p orbitals on the valence band of bare g-C3N4 which eventually contributes to increase the efficiency. Furthermore, the sulfur doping