Search results
Search for "optical characterization" in Full Text gives 37 result(s) in Beilstein Journal of Nanotechnology.
Morphology of SiO2 films as a key factor in alignment of liquid crystals with negative dielectric anisotropy
Beilstein J. Nanotechnol. 2016, 7, 1743–1748, doi:10.3762/bjnano.7.167
- spectroscopic ellipsometer (VASE) from J.A. Woollam Co., Inc. was used for optical characterization. The six generalized ellipsometry (GE) parameters Ψ, Ψsp, Ψps, Δ, Δsp, and Δps are linked to the Jones matrices of the reflected (Jr) or transmitted (Jt) beam via following equations [20]: where Jpp, Jss, Jsp
Electric field induced structural colour tuning of a silver/titanium dioxide nanoparticle one-dimensional photonic crystal
Beilstein J. Nanotechnol. 2016, 7, 1404–1410, doi:10.3762/bjnano.7.131
- is still obtained with a blurred interface. For the electro-optical characterization, we placed another ITO substrate on the other side of the photonic crystal and applied an external voltage to provide an electric field to the photonic crystal device. The electro-optical measurement is shown in
Investigating organic multilayers by spectroscopic ellipsometry: specific and non-specific interactions of polyhistidine with NTA self-assembled monolayers
Beilstein J. Nanotechnol. 2016, 7, 544–553, doi:10.3762/bjnano.7.48
- solvent. For ex situ optical measurements the NTA/Au samples were rinsed with ethanol and dried with N2 flow. A subset of NTA/Au samples were transferred in a salt buffer solution (20 mM Tris and 150 mM NaCl, pH 7.4) for subsequent characterization and treatments. After a first optical characterization in
Characterization of nanostructured ZnO thin films deposited through vacuum evaporation
Beilstein J. Nanotechnol. 2015, 6, 971–975, doi:10.3762/bjnano.6.100
- reorganization and coarsening, which permit the formation of the worm-shaped nanostructured thin films at 600 °C. This organization could be the cause of the increasing transparency of the thin films. Optical properties Optical characterization helps to trace the evolution and allow determining how the heat
Experimental determination of the light-trapping-induced absorption enhancement factor in DSSC photoanodes
Beilstein J. Nanotechnol. 2015, 6, 886–892, doi:10.3762/bjnano.6.91
- optical functionality of novel photoanode structures. Keywords: dye-sensitized solar cells; light trapping; optical characterization; photoanode modeling; titania nanostructures; Introduction The exploitation of solar irradiation, in particular by the use of photovoltaic (PV) technologies, is a widely
- careful experimental optical characterization of porous, thick titania electrodes and an optical four flux model to interpret experimental data. All the high efficiency cells reported in the literature exploit LT by both incorporating an additional scattering film [2][8][9] to reflect the light not yet
- optical characterization. The thickness of the electrodes was 6.5 μm as measured by a mechanical profilometer (Tencor Alphastep). The PA and the catalyzed cathodes were assembled into a sandwich-type cell and sealed with a 60 μm thick Surlyn® gasket. The electrolyte, a 2 M LiI solution in acetonitrile
Poly(styrene)/oligo(fluorene)-intercalated fluoromica hybrids: synthesis, characterization and self-assembly
Beilstein J. Nanotechnol. 2014, 5, 2450–2458, doi:10.3762/bjnano.5.254
- precipitated polymer was collected by filtration, repeatedly washed with fresh MeOH and dried in vacuum to constant weight (yield = 0.615 g; styrene conversion = 31%; Mw = 30.3 × 104 g/mol; Mw/Mn = 2.0) Preparation of films Films for optical characterization were obtained by casting or spin-coating a 20 mg·mL
Characterization of 10,12-pentacosadiynoic acid Langmuir–Blodgett monolayers and their use in metal–insulator–metal tunnel devices
Beilstein J. Nanotechnol. 2014, 5, 2240–2247, doi:10.3762/bjnano.5.233
- controlled using the KSV NIMA LB Trough controller. For polymerization purposes, the monolayers were exposed to 245 nm UV radiation for 15 min using a UV bench lamp [17]. Optical characterization: A Jasco FTIR 4600 was used to perform IR spectroscopy on the PDA film in transmission mode. IR transparent Si
Optical and structural characterization of oleic acid-stabilized CdTe nanocrystals for solution thin film processing
Beilstein J. Nanotechnol. 2014, 5, 881–886, doi:10.3762/bjnano.5.100
- lower than 2.4 mmol, impurity-free CdTe colloids were obtained. Optical characterization According to Figure 2, our CdTe colloids display a strong red luminescence, indicating quantum confinement in the nanosized CdTe crystals. It is known that quantum confinement can be observed for crystallite sizes
Surface passivation and optical characterization of Al2O3/a-SiCx stacks on c-Si substrates
Beilstein J. Nanotechnol. 2013, 4, 726–731, doi:10.3762/bjnano.4.82
- study the surface passivation of aluminum oxide/amorphous silicon carbide (Al2O3/a-SiCx) stacks on both p-type and n-type crystalline silicon (c-Si) substrates as well as the optical characterization of these stacks. Al2O3 films of different thicknesses were deposited by thermal atomic layer deposition
- the surface recombination velocity (Seff,max) was deduced from the effective lifetime τeff measurements as a function of the excess carrier density (Δn) at 1 sun injection level as where W is the substrate thickness and an infinite bulk lifetime has been assumed. Concerning the optical
- characterization, the thickness and refractive index of the individual Al2O3 and SiCx layers were measured by ellipsometry (Plasmos SD 2100) at a wavelength of 632 nm. Finally, in order to know the optical absorbance, we also deposited the same Al2O3/a-SiCx stacks on transparent substrates (Borosilicate glass
Modulation of defect-mediated energy transfer from ZnO nanoparticles for the photocatalytic degradation of bilirubin
Beilstein J. Nanotechnol. 2013, 4, 714–725, doi:10.3762/bjnano.4.81
- (Figure 1b). Following the optical characterization of the ZnO nanoparticle samples, we have explored the effect of the concentration of the surface defects in the ZnO nanoparticles on the photocatalytic degradation of BR, when using the nanoparticles as a photocatalyst medium. The photocatalytic
Characterization and properties of micro- and nanowires of controlled size, composition, and geometry fabricated by electrodeposition and ion-track technology
Beilstein J. Nanotechnol. 2012, 3, 860–883, doi:10.3762/bjnano.3.97
- range of diameters. Lai et al. reported the synthesis of ZnO nanowires using a ZnSO4-based electrolyte at 22 °C, and a Zn(NO3)2-based solution at 70 °C [92]. Enculescu and co-authors reported the fabrication and optical characterization of ZnO wires with diameters between 80 nm and 1.5 µm, deposited in
Plasmonic nanostructures fabricated using nanosphere-lithography, soft-lithography and plasma etching
Beilstein J. Nanotechnol. 2011, 2, 448–458, doi:10.3762/bjnano.2.49
- obtained in two steps: 80 nm + 100 nm. Figure 2 presents examples of PS coated spheres and hemispheres of the same diameter. The cast reproduced the topography of two-dimensional crystal very well. Distortions of the spherical shape only occurred for small spheres (400 nm). Optical characterization The
Other Beilstein-Institut Open Science Activities
