About the activity and selectivity of less well-known metathesis catalysts during ADMET polymerizations

• Hatice Mutlu,
• Lucas Montero de Espinosa,
• Oĝuz Türünç and
• Michael A. R. Meier

Beilstein J. Org. Chem. 2010, 6, 1149–1158, doi:10.3762/bjoc.6.131

• from Radleys. Stirring was continued at the selected temperature under a continuous flow of nitrogen for 5 h. After 5 h reaction time, the reaction mixture was dissolved in 1 mL of THF and polymerization halted by the addition of 1 mL of ethyl vinyl ether. The mixture was then stirred for 30 min at

Self-assembly and semiconductivity of an oligothiophene supergelator

• Pampa Pratihar,
• Suhrit Ghosh,
• Vladimir Stepanenko,
• Sameer Patwardhan,
• Ferdinand C. Grozema,
• Laurens D. A. Siebbeles and
• Frank Würthner

Beilstein J. Org. Chem. 2010, 6, 1070–1078, doi:10.3762/bjoc.6.122

• , and then cooled to 0 °C in an ice-bath. To this solution, a solution of 2, 2´-bithiophene in dry THF (68.0 mg in 5 mL) was added dropwise under continuous flow of argon. A white solid precipitate was formed. The reaction mixture was stirred at room temperature for 1 h and then immersed in an ice-bath

• product was dissolved in 20 mL dry DMF, compound 9 added and the flask evacuated, purged three times with argon and ~15 mg of the Pd-catalyst added under continuous flow of argon. The reaction mixture was then heated at 80 °C for 8 h under an argon atmosphere. It was observed that an orange precipitate

Kinetics and mechanism of vanadium catalysed asymmetric cyanohydrin synthesis in propylene carbonate

• Michael North and
• Marta Omedes-Pujol

Beilstein J. Org. Chem. 2010, 6, 1043–1055, doi:10.3762/bjoc.6.119

• achieved at atmospheric pressure and room temperature [74][75][76][77], or in a gas-phase continuous flow reactor [78], thus facilitating the use of waste carbon dioxide in this process [79]. In this paper we give full details of the use of catalyst 2 in propylene carbonate, and describe kinetic studies

Continuous flow enantioselective arylation of aldehydes with ArZnEt using triarylboroxins as the ultimate source of aryl groups

• Julien Rolland,
• Xacobe C. Cambeiro,
• Carles Rodríguez-Escrich and
• Miquel A. Pericàs

Beilstein J. Org. Chem. 2009, 5, No. 56, doi:10.3762/bjoc.5.56

• : asymmetric synthesis; continuous flow; diarylmethanols; solid-supported catalyst; triarylboroxins; Introduction Diarylmethanols constitute the basic scaffold in several important drugs such as antihistamines and muscle relaxants (R)-neobenodine, (R)-orphenadrine or (S)-carbinoxamine (Figure 1) [1]. Despite

• -pass, continuous flow highly enantioselective ethylation of aldehydes characterized by very short residence times (down to 2.8 min) [23]. According to these precedents, we considered that 2 could be a good candidate for a planned continuous enantioselective production of diarylmethanols. When a large

• continuous flow enantioselective processes [52] are still scarce [22][53][54][55][56][57] in spite of the enormous potential of this methodology. Herein, we report the development of a continuous flow system for the preparation of enantioenriched diarylmethanols using triarylboroxins as the ultimate aryl

Acid- mediated reactions under microfluidic conditions: A new strategy for practical synthesis of biofunctional natural products

• Katsunori Tanaka and
• Koichi Fukase

Beilstein J. Org. Chem. 2009, 5, No. 40, doi:10.3762/bjoc.5.40

• prominent biological activity in a “practical” and a “industrial” manner. Keywords: acid-mediated reaction; microreactor; natural products synthesis; oligosaccharide; pristane; Introduction A continuous flow microreactor, an innovative technology, has been used to realize efficient mixing and fast heat

• problems, we used a continuous flow microreactor. An application of the microfluidic system to the glycosylation reaction was first reported by Seeberger and co-workers on α-mannosylation [18]. We also have established an efficient microfluidic glycosylation in combination with the affinity separation

• the synthetic procedure, therefore, we used a continuous flow microreactor. Optimal conditions for reductive opening of 4,6-O-benzylidene acetals by a microfluidic system, similar to the α-sialylation and the β-mannosylation protocols, were examined using the glucose 4,6-O-benzylidene acetal 7 (Table

Gold film- catalysed benzannulation by Microwave- Assisted, Continuous Flow Organic Synthesis (MACOS)

• Gjergji Shore,
• Michael Tsimerman and
• Michael G. Organ

Beilstein J. Org. Chem. 2009, 5, No. 35, doi:10.3762/bjoc.5.35

• of gold, copper, silver, and gold-on-silver were prepared and evaluated for their catalytic activity in the microwave-assisted, continuous flow benzannulation of aryl, alkyl and silylalkynes with alkynylbenzaldehydes. Only the gold-on-silver films possessed both the high level of catalytic activity

Radical carbonylations using a continuous microflow system

• Takahide Fukuyama,
• Md. Taifur Rahman,
• Naoya Kamata and
• Ilhyong Ryu

Beilstein J. Org. Chem. 2009, 5, No. 34, doi:10.3762/bjoc.5.34

• pressurized carbon monoxide gas. Good to excellent yields of carbonylated products were obtained via radical formylation, carbonylative cyclization and three-component coupling reactions, using tributyltin hydride or TTMSS as a radical mediator. Keywords: continuous flow system; microreactor; radical

Controlling hazardous chemicals in microreactors: Synthesis with iodine azide

• Johan C. Brandt and
• Thomas Wirth

Beilstein J. Org. Chem. 2009, 5, No. 30, doi:10.3762/bjoc.5.30

• Johan C. Brandt Thomas Wirth Cardiff University, School of Chemistry, Park Place, Cardiff CF10 3AT, UK. 10.3762/bjoc.5.30 Abstract Aromatic aldehydes have been converted into the corresponding carbamoyl azides using iodine azide. These reactions have been performed safely under continuous flow

From discovery to production: Scale- out of continuous flow meso reactors

• Peter Styring and
• Ana I. R. Parracho

Beilstein J. Org. Chem. 2009, 5, No. 29, doi:10.3762/bjoc.5.29

• Peter Styring Ana I. R. Parracho Department of Chemical & Process Engineering, The University of Sheffield, Mappin Street, Sheffield S1 3JD, United Kingdom 10.3762/bjoc.5.29 Abstract A continuous flow parallel reactor system has been developed to provide a rapid and seamless transition from the

• a full analysis. By replication of the single reactor in parallel, the same chemistry can be achieved on a larger scale, on a small footprint and without the mass and heat transport limitations of reactor scale-out in batch. Keywords: catalysis; continuous flow; Kumada reaction; parallel; scale-out

• Suzuki and Heck coupling reactions at elevated temperatures while the nickel catalyst is active in the Kumada coupling [11][12] reaction at room temperature in batch (Scheme 1) and continuous flow reactors. In the latter, the catalyst is packed into a 3 mm diameter glass reactor tube of length 25 mm and

The development and evaluation of a continuous flow process for the lipase- mediated oxidation of alkenes

• Charlotte Wiles,
• Marcus J. Hammond and
• Paul Watts

Beilstein J. Org. Chem. 2009, 5, No. 27, doi:10.3762/bjoc.5.27

• lipase B, Novozym® 435, in a preliminary investigation into the development of a continuous flow reactor capable of performing the chemo-enzymatic oxidation of alkenes in high yield and purity, utilising the commercially available oxidant hydrogen peroxide (100 volumes). Initial investigations focussed

• on the lipase-mediated oxidation of 1-methylcyclohexene, with the optimised reaction conditions subsequently employed for the epoxidation of an array of aromatic and aliphatic alkenes in 97.6 to 99.5% yield and quantitative purity. Keywords: Candida antarctica lipase B; continuous flow; epoxidation

• alternative to traditional techniques. With this in mind, we report herein the development and evaluation of continuous flow technique for the enzyme-mediated synthesis of epoxides, employing the immobilised Candida antarctica lipase B, Novozym® 435 (4). This was recently found to be the most efficient

Continuous flow based catch and release protocol for the synthesis of α-ketoesters

• Alessandro Palmieri,
• Steven V. Ley,
• Anastasios Polyzos,
• Mark Ladlow and
• Ian R. Baxendale

Beilstein J. Org. Chem. 2009, 5, No. 23, doi:10.3762/bjoc.5.23

• chemical syntheses [38][39][40][41][42][43][44][45][46][47][48][49][50][51][52][53][54]. In this work we report the use of the Uniqsis FlowSyn™ continuous flow reactor [55] (Figure 1) to effect a flow-based preparation of α-ketoesters. The key feature of this process is the application of a catch and

• promote the base-catalysed dehydration, affording the nitroolefinic esters 1 (Scheme 2) [105]. As we have deliberately constructed this sequence for implementation in a continuous flow process, the intermediate nitroalkanols 5 were not isolated and the nitroolefinic esters were used without further

• Uniqsis FlowSyn™ unit to achieve multi-step organic synthesis under continuous flow-chemistry conditions. This was accomplished by adapting the device to incorporate immobilised reagents packed in flow tubes, enabling clean transformations without recourse to conventional product work-up or purification

Polyionic polymers – heterogeneous media for metal nanoparticles as catalyst in Suzuki–Miyaura and Heck–Mizoroki reactions under flow conditions

• Klaas Mennecke and
• Andreas Kirschning

Beilstein J. Org. Chem. 2009, 5, No. 21, doi:10.3762/bjoc.5.21

• heterogeneous supports for palladium(0) nanoparticles is described. These functionalized polymers were incorporated inside a flow reactor and employed in Suzuki–Miyaura and Heck cross couplings under continuous flow conditions. Keywords: Heck–Mizoroki reaction; heterogeneous catalysis; ion exchange resin

• heterogenization of transition metals. A major hurdle for industrial applications of heterogenized homogeneous metal catalyst is associated with keeping metal leaching down to a minimum. Immobilization can be regarded as one enabling technique in organic chemistry [5][6] that in conjunction with continuous flow

• transition metals on solid phases inside monolithic flow reactors [9][10][11][12][13][14][15][16][17][18] we describe the preparation of palladium nanoparticles loaded on polyionic polymers and their use under continuous flow conditions in various C-C-cross-coupling reactions [19][20][21][22]. Results and

Asymmetric reactions in continuous flow

• Xiao Yin Mak,
• Paola Laurino and
• Peter H. Seeberger

Beilstein J. Org. Chem. 2009, 5, No. 19, doi:10.3762/bjoc.5.19

• Xiao Yin Mak Paola Laurino Peter H. Seeberger Department of Biomolecular Systems, Max Planck Institute of Colloids and Interfaces, Research Campus Golm, D-14424 Potsdam, Germany 10.3762/bjoc.5.19 Abstract An overview of asymmetric synthesis in continuous flow and microreactors is presented in

• this review. Applications of homogeneous and heterogeneous asymmetric catalysis as well as biocatalysis in flow are discussed. Keywords: asymmetric catalysis; biocatalysis; continuous flow; microreactors; solid phase synthesis; Introduction While many technological advancements have been made over

• reproducibility due to the precise control over reaction conditions in these devices. Continuous flow technology has excellent potential for the integration of a high level of automation and for the incorporation of on-demand reaction analysis. This can be advantageous for applications such as high-throughput

A biphasic oxidation of alcohols to aldehydes and ketones using a simplified packed- bed microreactor

• Andrew Bogdan and
• D. Tyler McQuade

Beilstein J. Org. Chem. 2009, 5, No. 17, doi:10.3762/bjoc.5.17

• potential as continuous flow processes. Realizing this, we developed a catalytic packed-bed microreactor that could be used for the continuous flow oxidation of alcohols to aldehydes or ketones. Oxidations that do not require transition metal catalysts are particularly appealing since there is neither

Chemistry in flow systems

• Andreas Kirschning

Beilstein J. Org. Chem. 2009, 5, No. 15, doi:10.3762/bjoc.5.15

• focus on the development of flow devices for laboratory use and hence for industrial applications. An important field of research is the optimization and adaptation of known reactions and reaction sequences for use in flow systems. Advantageously, continuous-flow processes can be further improved by